Elbow part hex meshing

Discussion about meshing issues.

Elbow part hex meshing

Postby ggiannak » Thu Jul 20, 2017 1:38 am

Dear all,

I have been trying to generate a hex mesh for the attached elbow part, but
I cannot find the volume decomposition needed to achieve a _good_ quality
mesh. A restriction is that the outlet surface should be meshed using the "hole"
scheme, and preferably the inlet with “circle” (see attached journal file).

Meshing of this geometry using other software is done by using multiple o-grid blocks,
however this is very difficult to be realized by hand in Cubit/Trelis.

Has anybody faced a similar problem before? Any help would be greatly appreciated.

Thanks,
George
You do not have the required permissions to view the files attached to this post.
ggiannak
 
Posts: 2
Joined: Tue Jun 30, 2015 4:20 pm

Re: Elbow part hex meshing

Postby ggiannak » Sat Jul 22, 2017 8:09 am

Any ideas?
ggiannak
 
Posts: 2
Joined: Tue Jun 30, 2015 4:20 pm


Return to Meshing

Who is online

Users browsing this forum: No registered users and 1 guest

cron

Search / Mark

User Control Panel

Login

Who is online

In total there is 1 user online :: 0 registered, 0 hidden and 1 guest (based on users active over the past 5 minutes)
Most users ever online was 58 on Mon Jun 26, 2017 4:19 pm

Users browsing this forum: No registered users and 1 guest