Surface bias direction

Discussion about meshing issues.

Surface bias direction

Postby Cubit User » Wed Aug 01, 2012 2:44 pm

When putting a boundary layer mesh on a surface, I use the interval and bias setting for many edges. I find it quite tedious to reverse the bias direction for a particular edge (about 50 in my decomposed geometry). Is there a simple mouse click, for example, that is available to reverse the direction of a particular edge, or some other simple trick. My geometry is cylindrical in nature and so I cannot specify a particular Cartesian direction vector (unless I could put a cylindrical coord on my geometry).
Cubit User
Posts: 44
Joined: Wed May 16, 2012 12:42 pm

Re: Surface bias direction

Postby csimsoft Moderator » Wed Aug 01, 2012 2:46 pm

In the Cubit GUI there is a panel that allows the user to view the sense of curves and modify it. In the Command Panel, click on Geometry->Curve->Modify->Sense. You then can pick the curves that need their sense viewed; probably the curves that are getting a bias applied to them. In the 'Align Curve' portion of the panel below, you can reverse the sense of a subset of the curves. You still have to pick each curve in order to view or modify its sense.

Another solution might be to use the 'propagate bias' command:

Propagate Curve Bias [surface|volume|body|group <id_list>]
csimsoft Moderator
Posts: 237
Joined: Tue Feb 14, 2012 5:59 pm
Location: American Fork, UT

Return to Meshing

Who is online

Users browsing this forum: Google [Bot] and 1 guest


Search / Mark

User Control Panel


Who is online

In total there are 2 users online :: 1 registered, 0 hidden and 1 guest (based on users active over the past 5 minutes)
Most users ever online was 58 on Mon Jun 26, 2017 4:19 pm

Users browsing this forum: Google [Bot] and 1 guest