How to mesh a brick chopped with a partail sphere

Discussion about meshing issues.

How to mesh a brick chopped with a partail sphere

Postby yuhongyu » Fri Jul 05, 2013 3:50 am

I failed to mesh a brick chopped by a partial sphere, as the attached file 'model.jpg'show.Sorry I cannot upload the cub file. If needed, I can email to you.
I'm very graceful to have some one who can help me with this problem.
You do not have the required permissions to view the files attached to this post.
yuhongyu
 
Posts: 3
Joined: Wed Jun 26, 2013 7:29 am

Re: How to mesh a brick chopped with a partail sphere

Postby csimsoft Moderator » Tue Jul 23, 2013 12:05 pm

To mesh the brick, you will need to make a single webcut. Open the .cub file

delete mesh
webcut volume 30 32 yplane offset -7.5
unmerge all
imprint all
merge all
volume all scheme auto
mesh volume all
csimsoft
csimsoft Moderator
 
Posts: 239
Joined: Tue Feb 14, 2012 5:59 pm
Location: American Fork, UT


Return to Meshing

Who is online

Users browsing this forum: No registered users and 1 guest

cron

Search / Mark

User Control Panel

Login

Who is online

In total there is 1 user online :: 0 registered, 0 hidden and 1 guest (based on users active over the past 5 minutes)
Most users ever online was 58 on Mon Jun 26, 2017 4:19 pm

Users browsing this forum: No registered users and 1 guest