ERROR: No entity with ID ** was found

Discussion about meshing issues.

ERROR: No entity with ID ** was found

Postby drobinson » Wed Jul 10, 2013 8:59 am

I'm finding a recurrent error appearing for a mesh I'm trying to create, where I am told that a particular ID was not found. This error continuously appeared for one particular surface, then went, then came back but with a different surface ID failing to be found.

To be clear, the entire geometry has been created, the surfaces and volumes have been meshed. I've been able to apply side-sets to all surfaces (including to the surface who's ID cannot be found), but I cannot export the mesh successfully whilst the error is present.

Any ideas?
drobinson
 
Posts: 1
Joined: Wed Jul 10, 2013 8:50 am

Re: ERROR: No entity with ID ** was found

Postby csimsoft Moderator » Fri Jul 19, 2013 10:12 am

Are you importing a step or iges file? Our third-party solid modeler, ACIS, has a known problem of inconsistent numbering when importing a step or iges file. The best work-around we have is to import the step/iges file, then save it out as a sat file. From then on, only work off the sat file. This should give you consistent results from one session to another.
csimsoft
csimsoft Moderator
 
Posts: 247
Joined: Tue Feb 14, 2012 5:59 pm
Location: American Fork, UT


Return to Meshing

Who is online

Users browsing this forum: No registered users and 1 guest

Search / Mark

User Control Panel

Login

Who is online

In total there is 1 user online :: 0 registered, 0 hidden and 1 guest (based on users active over the past 5 minutes)
Most users ever online was 58 on Mon Jun 26, 2017 4:19 pm

Users browsing this forum: No registered users and 1 guest