visualizing the mesh internal to a volume

Discussion about meshing issues.

visualizing the mesh internal to a volume

Postby Cubit User » Fri May 18, 2012 2:30 pm

I'm trying to visualize the mesh inside a volume per the
startup tips, but all I get is the surface mesh and an
empty interior (a volume mesh does exist).

I've also tried "graphics slice" from the command line
but claro dumps core immediately.

This is with 13.1. Any clues about what I'm doing wrong?

Thanks,
Cubit User
 
Posts: 44
Joined: Wed May 16, 2012 12:42 pm

Re: visualizing the mesh internal to a volume

Postby csimsoft Moderator » Fri May 18, 2012 2:33 pm

By default cubit only draws the exterior of the mesh to speed graphics display. With clipping on, try typing

draw hex all

at the command line to get the internal elements as well.

-- Karl
csimsoft
csimsoft Moderator
 
Posts: 244
Joined: Tue Feb 14, 2012 5:59 pm
Location: American Fork, UT


Return to Meshing

Who is online

Users browsing this forum: No registered users and 1 guest

cron

Search / Mark

User Control Panel

Login

Who is online

In total there is 1 user online :: 0 registered, 0 hidden and 1 guest (based on users active over the past 5 minutes)
Most users ever online was 58 on Mon Jun 26, 2017 4:19 pm

Users browsing this forum: No registered users and 1 guest