best way to mesh partial sphere inside a cube

Discussion about meshing issues.

best way to mesh partial sphere inside a cube

Postby rputikar » Thu Jan 16, 2014 1:38 am

Hello,

What is the best way to get structured mesh for a partial sphere inside a cube? I tried to follow the tips and tricks article http://csimsoft.com/partialsphere.jsp but couldn't get a good mesh. after the split with cylinder I get narrow surface message when I run checked diagnostics.

Thanks in advance, Ranjeet.

The geometry:
reset
create sphere radius 6.5 ypositive
create brick x 15.5 ypositive
move Volume 1 y -1.5 include_merged
move Volume 2 y 7.75 include_merged
subtract volume 1 from volume 2 imprint
rputikar
 
Posts: 2
Joined: Wed Jan 15, 2014 10:57 pm

Re: best way to mesh partial sphere inside a cube

Postby csimsoft Moderator » Tue Jan 21, 2014 11:43 am

Ranjeet,

For this model, would the Sweep mesh scheme work using surface 9 and 10 as the source surfaces and surface 7 as the target surface?
csimsoft
csimsoft Moderator
 
Posts: 237
Joined: Tue Feb 14, 2012 5:59 pm
Location: American Fork, UT

Re: best way to mesh partial sphere inside a cube

Postby rputikar » Tue Jan 28, 2014 10:01 pm

Yes it works! Thanks.
rputikar
 
Posts: 2
Joined: Wed Jan 15, 2014 10:57 pm


Return to Meshing

Who is online

Users browsing this forum: Google [Bot] and 1 guest

cron

Search / Mark

User Control Panel

Login

Who is online

In total there are 2 users online :: 1 registered, 0 hidden and 1 guest (based on users active over the past 5 minutes)
Most users ever online was 58 on Mon Jun 26, 2017 4:19 pm

Users browsing this forum: Google [Bot] and 1 guest