Page 1 of 1

Anyone has an idea of how to mesh this geometry?

PostPosted: Mon Jan 07, 2019 7:17 pm
by jamesk54
I try to web cut the geometry, finally came out with this (see attached figure). But the center piece could not be meshed with sweep or anything. Does anyone know a cutting method to mesh this geometry?

I really appreciate! Thank you for your time!

James

Re: Anyone has an idea of how to mesh this geometry?

PostPosted: Fri Feb 08, 2019 12:14 pm
by csimsoft Moderator
Were you able to mesh this model? Is it something you can share?